1. Install the drill jig when setting the mask in servant. Keep the jig in the case with the servant of snap-ring.
2. Drop the 9 / 16 “guide jig. No matter which one of the lands on the rail is used, as long as the land is under the 3 / 8″ Allen screw.
3. Ream the hole with the 9 / 16 “reamer, applying ample lubrication .* NOT stack above 500 rpm.
4. Replace 9 / 16 “with the guide reamer 5 / 8″ drive, and 9 / 16 “reamer with 5 / 8″ reamer.
5. Ream the hole using a 5 / 8 “reamer with ample lubrication .* Take care not to push too hard or the reamer reamer or rotate as fast as 500 rpm when reaming. Or you can enlarge the hole too, causing a loose bush .
6. Clean the case before proceeding to step number seven.
7. Apply Loctite ® (preferably green # 680) or equivalent for the bushing and guide bushing in hitting the driver until the bush funds. 5RW The kit uses a smaller diameter instrument installation identified by a groove cut in the handle.
8. After installing the bushing, with a 15/64 bit, drill a hole in the side of the bushing according to the holes in the case (use the appropriate image to the left, like a map).
9. Insert the pin into the hole size required. You may have to start in the pivot bushing with a rubber mallet. Once the pin is in the bush, use a punch to drive the pins all the way through the bush. Repeat if necessary.
Download Ford Rotunda Approved SF99 Servo Bore Repair System PDF Manual
2. Drop the 9 / 16 “guide jig. No matter which one of the lands on the rail is used, as long as the land is under the 3 / 8″ Allen screw.
3. Ream the hole with the 9 / 16 “reamer, applying ample lubrication .* NOT stack above 500 rpm.
4. Replace 9 / 16 “with the guide reamer 5 / 8″ drive, and 9 / 16 “reamer with 5 / 8″ reamer.
5. Ream the hole using a 5 / 8 “reamer with ample lubrication .* Take care not to push too hard or the reamer reamer or rotate as fast as 500 rpm when reaming. Or you can enlarge the hole too, causing a loose bush .
6. Clean the case before proceeding to step number seven.
7. Apply Loctite ® (preferably green # 680) or equivalent for the bushing and guide bushing in hitting the driver until the bush funds. 5RW The kit uses a smaller diameter instrument installation identified by a groove cut in the handle.
8. After installing the bushing, with a 15/64 bit, drill a hole in the side of the bushing according to the holes in the case (use the appropriate image to the left, like a map).
9. Insert the pin into the hole size required. You may have to start in the pivot bushing with a rubber mallet. Once the pin is in the bush, use a punch to drive the pins all the way through the bush. Repeat if necessary.
Download Ford Rotunda Approved SF99 Servo Bore Repair System PDF Manual
Tidak ada komentar:
Posting Komentar