Before installation, familiarize your-own with the instructions for installation and ultrasonic parking assist system. To ensure your safety:
A) Make sure the vehicle is in “PARK”.
B) Request for emergency brake.
C) Read this manual before starting.
CAUTION: It is appropriate to disconnect the negative battery cable for 3 minutes before the start of installation to avoid unintended airbag deployment. Note and record Anti-theft radio code before disconnecting.
STEP 1: VEHICLE PREPARATION
1. Lift the trunk. Remove the back door scuff panel and pull back luggage matt. (Figure1). The issue of personal side-lining of the trunk. Remove cover for the tire rubber strap.
STEP 2: SENSOR LOCATION
1. If you are using a Mylar template, aligned with the surface of the bumper. Make sure that the template is the center of the bumper horizontally. Use the torso or the back latch bar as a reference for the centerpoint and the use of arrows and lines printed on the template as a guide. Secure the template to bumper with masking tape.
2. U (4) sensor applications, to measure the width of the bumper and mark the place on the 1 / 8 and 3 / 8 at a distance from each end, as shown in figure 2 U (2) Sensor applications, instead of one sensor on a 1 / 4 distance from each end. The ideal location will be 18 “-22″ from the ground. Mark the holes in the template on the bumper. With 22 mm or 7 / 8 “hole-saw, drill holes on four marked points. Hold drill a constant level so that the holes are drilled perpendicular to the surface of the bumper. Use for deburring drill carefully remove any plastic in the holes (Fig. 3).
Download Ford Mustang Ultrasonic Parking Assist System PDF Installation Manual
A) Make sure the vehicle is in “PARK”.
B) Request for emergency brake.
C) Read this manual before starting.
CAUTION: It is appropriate to disconnect the negative battery cable for 3 minutes before the start of installation to avoid unintended airbag deployment. Note and record Anti-theft radio code before disconnecting.
STEP 1: VEHICLE PREPARATION
1. Lift the trunk. Remove the back door scuff panel and pull back luggage matt. (Figure1). The issue of personal side-lining of the trunk. Remove cover for the tire rubber strap.
STEP 2: SENSOR LOCATION
1. If you are using a Mylar template, aligned with the surface of the bumper. Make sure that the template is the center of the bumper horizontally. Use the torso or the back latch bar as a reference for the centerpoint and the use of arrows and lines printed on the template as a guide. Secure the template to bumper with masking tape.
2. U (4) sensor applications, to measure the width of the bumper and mark the place on the 1 / 8 and 3 / 8 at a distance from each end, as shown in figure 2 U (2) Sensor applications, instead of one sensor on a 1 / 4 distance from each end. The ideal location will be 18 “-22″ from the ground. Mark the holes in the template on the bumper. With 22 mm or 7 / 8 “hole-saw, drill holes on four marked points. Hold drill a constant level so that the holes are drilled perpendicular to the surface of the bumper. Use for deburring drill carefully remove any plastic in the holes (Fig. 3).
Download Ford Mustang Ultrasonic Parking Assist System PDF Installation Manual
Tidak ada komentar:
Posting Komentar