Installation of a component or assembly should be performed by persons experienced in the installation and proper operation of disc brake systems. It is also the responsibility of the person to install a brake kit or component to determine the suitability of the component or the whole of this application.
NOTE: Before using the vehicle after the installation of the brake test, under controlled conditions. Make several stops in a safe area at low speed and gradually to a normal speed. Do not drive with the test BRAKES! Always use the security restrictions when using the vehicle.
STEP 1:
1. Verify that your file has all the necessary parts to this project! (Use the parts list provided in a checklist.)
STEP 2:
Delete the following elements of your car:
Tech tip: Before spraying disassembly nuts and bolts that were removed with a penetrance.
1. If you’re installing an outlet, make sure the parking brake is set and that the rear wheels are aligned. Support the front of the vehicle with jack stands. Never work on a slope.
2. If you use a lift, to lift the vehicle to a comfortable working height.
3. Remove the front tires.
4. At that time, be sure to place the proper support under the lower control arm. Not to allow the coil spring to move when the pin is removed, which could result in damage to the vehicle and possible serious injury or even death.
5. Then, remove the drum brake hoses get tough with the torch key.
6. Detach the steering arm of the bar.
7. Now, remove the head of the stem and remove the drum brake assembly as a unit.
8. Clean and inspect ball joints and tie the ends to excessive wear or damage, to replace at that time, if necessary, in view of the assembly.
Download Ford Full-Size DB1512M 1965-1972 PDF Installation Manual
NOTE: Before using the vehicle after the installation of the brake test, under controlled conditions. Make several stops in a safe area at low speed and gradually to a normal speed. Do not drive with the test BRAKES! Always use the security restrictions when using the vehicle.
STEP 1:
1. Verify that your file has all the necessary parts to this project! (Use the parts list provided in a checklist.)
STEP 2:
Delete the following elements of your car:
Tech tip: Before spraying disassembly nuts and bolts that were removed with a penetrance.
1. If you’re installing an outlet, make sure the parking brake is set and that the rear wheels are aligned. Support the front of the vehicle with jack stands. Never work on a slope.
2. If you use a lift, to lift the vehicle to a comfortable working height.
3. Remove the front tires.
4. At that time, be sure to place the proper support under the lower control arm. Not to allow the coil spring to move when the pin is removed, which could result in damage to the vehicle and possible serious injury or even death.
5. Then, remove the drum brake hoses get tough with the torch key.
6. Detach the steering arm of the bar.
7. Now, remove the head of the stem and remove the drum brake assembly as a unit.
8. Clean and inspect ball joints and tie the ends to excessive wear or damage, to replace at that time, if necessary, in view of the assembly.
Download Ford Full-Size DB1512M 1965-1972 PDF Installation Manual
Tidak ada komentar:
Posting Komentar